Den-Mat Sapphire Manual del operador descargar pdf (Pagina 20)

Lamp Replacement Instructions

WARNING: ONLY A QUALIFIED SERVICE TECHNICIAN MAY REPLACE THE SYSTEM LAMP.

PROTECTIVE EYEWEAR MUST BE WORN. NEVER POINT THE WINDOW OF THE LAMP TO

UNPROTECTED TISSUE.

Symptoms indicating need for replacement are:

1. Low intensity on system light meter.

2. Lamp fails while in use or does not turn on.

To Remove the Old Lamp

1. Turn unit off and unplug the power cord from its power source.

2. Wait for the unit and the lamp to cool.

3. Unscrew thumbscrews to remove the lamp access plate.

4. Grasp lamp and slide towards you to remove from light source.

5. Unplug the lamp from the 2-pin lamp socket.

To Insert New Lamp

1. Orient the lamp facing forward in the lamp guides on the chassis.

2. Push toward the top of the unit until the lamp slides securely onto the lamp pins.

3. Replace the lamp access plate and tighten thumbscrews.

NOTE: Make sure the access plate ﬁts correctly in the cutout provided. All corners should be even with the

surrounding surfaces. If the access plate is misaligned, the unit may not receive AC power.

Unscrew thumbscrews

to remove access door.

HANDLES BRASS SOCKETS

1 2 ... 15 16 17 18 19 20 21 22 23 24

Sin comentarios

Den-Mat Sapphire Manual del operador Pagina 20