Den-Mat Sapphire Manual del operador descargar pdf (Pagina 16)

STM (Soft Tissue Management)

3W Diode Laser Mode Settings

NOTE: DO NOT ATTEMPT TO OPERATE THE SAPPHIRE

PLUS STM 3W DIODE LASER SYSTEM

WITHOUT FIRST READING AND UNDERSTANDING ALL LASER SAFETY INSTRUCTIONS.

For complete information on using the Sapphire Plus STM 3W Diode Laser and performing STM 3W Diode

Laser procedures, refer to the Sapphire Plus STM 3W Diode Laser Instructions for Use documentation.

Warning: Laser Safety Eye Protection MUST BE WORN by the Operator, Patient, Assistant,

and anyone present when the laser is activated. Eye Protection must conform to Speciﬁcation

DIN EN207 Annex II of the Directive 89/686/EEC with optical density in 800nm-818nm of

OD 4+ such as NoIR Laser Company ﬁlter model DII.

The STM 3W Diode Laser offers two operation modes: CW (CONTINUOUS WAVE) and PULSE (4Hz). The

following instructions will describe how to control both.

Remove the black adapter insert (if present) from the light guide port of the Sapphire Plus System and insert the

STM 3W Diode Laser Control Module into the light guide port. Insert the Sapphire Plus STM key into the

Sapphire Plus STM Diode Laser unit and turn it to the “ON” position. Plug the STM 3W Diode Laser handpiece

into the Light Guide Port on the Laser Unit. When the STM 3W Diode Laser handpiece is attached to the STM

3W Diode Laser unit, the auto-detect feature will activate the unit and cause the display to light. The unit will then

be in STAND-BY status.

CHARGE BATTERY BEFORE USING:

Upon receipt, install the Sapphire Plus

Soft Tissue Management (STM) control

module into the Sapphire Plus light

source. Turn the power switch of the

Sapphire Plus light source ON. For a

more rapid charge, use the auxiliary

power supply provided with the Sapphire

Plus STM system. Plug the auxiliary power

supply into an AC outlet and insert the

plug into the STM control module.

NOTE: All Sapphire plus attachments can be plugged into the Sapphire Plus when the STM control panel is

installed. For use of non-Laser attachments, the key must be turned to the “OFF” position.

With the key in the “ON” position and the STM 3W Diode Laser handpiece attached, the unit defaults to the

Continuous Wave (CW) mode and the indicator light next to CW on the control panel turns on. The power

setting will default to 0.8 Watts and will be displayed in the LASER POWER window.

NOTE: A ﬂashing red “READY” indicator light and blank LASER POWER window indicate that additional power

is required and that the STM 3W Diode Laser auxiliary power supply must be attached to the jack on the side of

the STM Control Unit.

Power can be adjusted by using the UP and DOWN arrow keys to increase (up) or decrease (down) the power.

Settings may not be changed when the laser working beam is emitting.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Sin comentarios

Den-Mat Sapphire Manual del operador Pagina 16